Shift Transport Planning in Zonguldak: Where Routes Break and How to Keep Them Whole
A shift bus that arrives eight minutes late is not an eight-minute problem. At a plant in Çaycuma it means the night crew cannot hand over, the day crew waits at the gate, and someone gets a phone call. Most of what we do in shift transport planning comes down to preventing that chain from starting.
Why Zonguldak is different from a flat-city shift plan
Anyone who has planned staff transport in a flat, grid-like city will find Zonguldak uncomfortable at first. The terrain does the planning for you, and not always kindly. The coastal road between Zonguldak center, Kozlu and Kilimli carries heavy mixed traffic, and the uphill neighbourhoods above the center have streets where a 45-seat bus simply cannot turn. Çaycuma sits on a different axis again, with the Devrek and Bartın directions pulling workers from villages that have one narrow road in and out.
So a route is never just a list of stops. It is a list of stops that a specific vehicle can physically reach, in a specific order, at a specific hour, in a specific season. Change any one of those and the plan changes with it.
Start from the handover, not from the map
The most common mistake we see when an employer sends us a worker address list is that the planning starts from the addresses. We start from the shift handover time instead. If the gate opens at 06:00 and the outgoing crew leaves at 06:15, the bus that brings the incoming crew has to arrive between those two points, not at 05:58 because that is when the route happened to finish.
Working backwards from the handover gives you the latest possible departure from the first pickup. That number is usually uncomfortable, because it often means the first worker is picked up earlier than they expected. It is better to have that conversation in the planning stage than on the first Monday.
Group workers by shift, then by direction
Mixed-shift routes look efficient on paper. One bus, one route, three shifts of workers sharing it. In practice they are fragile. When one worker swaps a shift, the whole route geometry changes, and the bus ends up running half empty in one direction and overloaded in the other.
We prefer to build routes around a single shift pattern wherever the headcount allows it, and only then group by direction: the Çaycuma side, the center and Kozlu side, the Ereğli direction. Where headcount is small, a shared route is fine, but it needs a clear rule about who can change shifts and how much notice the operation needs.
Buffers that are honest
Every route needs a buffer, and the buffer needs to be sized for the real worst case on that road, not the average. A few examples of what we actually build in:
- Extra minutes on any leg that crosses a level crossing or a single-lane bridge section.
- A longer allowance for the first morning of the week and the first morning after a public holiday, when traffic behaves differently.
- A separate, longer timing for the evening run after a rain day, since the coastal road slows down noticeably.
A buffer that is too generous wastes worker time and makes the route unpopular. One that is too thin gets used up on the first foggy morning. We adjust ours after the first two weeks of real running, once we have actual timings instead of estimates.
Winter changes the plan, not just the driving
From December onward, the higher villages and the uphill streets in town behave differently. A route that runs fine in October may need a different pickup point in January because the bus cannot safely climb or stop on the original street. We would rather agree on that alternative pickup point with the workers in advance than improvise it at 05:30 in the dark.
Practical points that matter in winter:
Vehicle readiness comes first. Tyres, heating and the defrost system are checked before the season, not when the first snow forecast appears. Drivers who know the route also know which stretch ices first and where the sun does not reach until late morning. That local knowledge is hard to replace with a navigation app.
Communication comes second. If a village road is closed, the shift supervisor and the workers need to hear it from one source, early, with a revised pickup instruction. Five different people calling five different workers is how people end up standing at the wrong stop.
Backup vehicles and what a real contingency looks like
A contingency plan that says "we will find a replacement vehicle" is not a plan. A real one names the replacement vehicle class, the driver who can take it, and the maximum time before it reaches the first stop. If a bus breaks down at the Kozlu end of a route, the question is not whether a backup exists but whether it can reach 40 workers before the shift starts. For short routes that is realistic. For long rural runs it needs a pre-positioned vehicle or a split plan.
We would encourage any HR or purchasing team to ask this question directly of any transport provider: what happens at 05:20 if the vehicle does not start? The quality of the answer tells you more than any fleet list.
Headcount changes and how to absorb them
Workforces in mining, energy and industrial sites do not stay still. A new project phase adds twelve people, a maintenance shutdown removes thirty for three weeks. A route plan that cannot flex is a route plan that gets abandoned. We keep vehicle capacity slightly above current headcount on most routes, and we agree in advance how many days of notice are needed to add a stop, merge two routes or release a vehicle during a shutdown.
The notice period is worth writing down. Not as a penalty clause, just as a shared understanding, so that nobody is surprised.
What to ask before you sign
If you are comparing options, these are the questions that separate a workable plan from a brochure:
- Which shift handover time is each route built around?
- What is the actual buffer on the longest leg, and how was it measured?
- Where are the winter alternative pickup points, and who tells the workers?
- What is the backup vehicle for each route, and how long to reach the first stop?
- How much notice is needed to change headcount or shift pattern?
None of these require a long meeting. They require someone who has run the roads and can answer without checking.
Talk to us about your shifts
If you are planning or reworking shift transport anywhere in Zonguldak, from Çaycuma to the center, Kozlu or Kilimli, send us your shift times and a rough worker distribution. Write to us through the quote form on zonguldakpersonelservisi.com or on WhatsApp, and we will go through it together.